![Menu](/graphics/menu/left_menu_blank.gif) |
FAQ, tips and tricks - Installation
What happens when both POWER and ACCESS LED's are blinking?
What can I do when password authentication fails to log on to the setup screen of the PX-EH25L?
- What happens when both POWER and ACCESS LED's are blinking?
The IP address of the PX-EH25L has not been obtained from a DHCP server
* If the PX-EH25L is set as a DHCP client (default setting) and a DHCP server cannot be found on the connected network, both the POWER and ACCESS lamps will blink.
Confirm that the DHCP server on the connected network is functioning properly.
* If you have connected the PX-EH25L according to the procedure described under 1, "Opening the Setup Screen", this status is not a problem. In this case, 192.168.0.200 will be assigned as the IP address of the PX-EH25L.
Top
- What can I do when password authentication fails to log on to the setup screen of the PX-EH25L?
The password is wrong.
If you forgot your password, revert the PX-EH25L to its default settings by referring to "Load Setup Defaults".
You may have set space characters as the password, avoid the use of SPACE character in any password.
Top
|
|
©2007 Plextor SA/NV, All rights reserved.
|
|